Start a new model
Choose File › New… or press Ctrl+N. The New model dialog opens.
- In the top bar, choose the Region. It sets the units and design codes. You can change them later.
- The gallery lists only bridges. Type overpass in Search templates to narrow it.
- Click Multi-span overpass: girder spans over single-column piers with haunched caps on pile caps.
- Choose Create model, or double-click the card.
Every bridge template is also in File › Samples, under Templates.
Set the parameters
The template’s parameters show in the Template panel, grouped as Geometry, Members, Supports, Loads and Analysis. Enter these values. The model is rebuilt after each change.
| Group | Parameter | Value |
|---|---|---|
| Geometry | Spans | 4*30 (four spans of 30 m) |
| Geometry | Deck width | 12 m |
| Geometry | Skew | 0° |
| Members | Superstructure | PSC girders |
| Members | Girder section | AASHTO BT-63 |
| Members | Girders | 5 |
| Members | Diaphragms per span | 3 |
| Members | Bent type | Single column |
| Members | Column size | 1500 mm |
| Supports | Foundations | Pile group |
| Supports | Bearings | Pot (fixed/guided/free) |
| Loads | Lanes | 2 |
| Analysis | Modes | 12 |
These are the template’s defaults, so you only need to check them. A value that doesn’t fit is marked in the panel; for example, too many columns for the deck width.
BIM model and analysis model
The 3D view shows the bridge as a BIM model: girders, deck, diaphragms, bearings, pier caps, columns, pile caps, piles and abutments as solids.
The analysis is run on the model converted from it: deck shells with the girders offset under them, bearings, piers and abutments. The view switches to the analysis model when you show the mesh or results.
Hover a part to see its name in the status bar, for example a pier column or a bearing.
Change it in the Template panel
If the panel is closed, open it from Options › Panels › Template panel.
- Change a parameter, such as Girders from 5 to 6, and the model is rebuilt with the new value.
- Edit alignment… at the top of the panel opens the horizontal alignment, vertical profile and cross-falls as tables, or reads a LandXML file. See Alignment.
- Set Girders back to 5 before you go on.
Run the modal and static analyses
- Choose Analysis › Modal. The first time you run OpenSees, a notice says that OpenSees is separate software under its own licence. Read it and choose I understand.
- When the run ends, the results show the periods and mode shapes. Use them to see how the bridge moves along and across.
- Choose Analysis › Linear static. The template made the load cases: self-weight, surfacing and barriers, and the lane load.
- Read the deflections, member forces and reactions in the Results panel.
If OpenSees isn’t found, the study stops with a message. Set the FEA_OPENSEES environment variable to OpenSees.exe. See Install and OpenSees.exe.
After an analysis the model is locked, so the results always match it. To edit it again, choose Results › Unlock model. That removes the results.
What you learned
- Bridges start from File › New…; every template is also a sample.
- The Template panel holds the parameters, and changing one rebuilds the model.
- The BIM model is what you see; the analysis model is what OpenSees solves.
- The first OpenSees run asks you to acknowledge its licence.