The bearing layout
The template parameter Bearings (group Supports) chooses Pot (fixed/guided/free) or Elastomeric for the whole bridge.
With pot bearings, each bearing follows the layout: fixed at the centre of the fixed support line, guided along the bridge at the centre of the other lines, and free elsewhere.
Change bearings
Click a bearing on an abutment in the 3D view. In the Template panel:
| Property | Choices or unit |
|---|---|
| Type | From the layout · Pot, fixed · Pot, guided (free along) · Pot, guided (free across) · Pot, free · Elastomeric |
| Plan size | mm (default 500) |
| Height | mm (default 150) |
Changes apply to offers this bearing, every bearing on the support, every bearing of the line (B1, B2, …) and every bearing.
For this tutorial, choose Every bearing on support … for that abutment and set Type to Elastomeric.
Shape the abutments
Click an abutment. Its properties are grouped as Abutment, Footing, Back wall, Wing wall, Approach slab and Piles. Changes apply to this abutment or both abutments.
| Group | Property | Value |
|---|---|---|
| Abutment | Wall thickness | 1000 mm |
| Approach slab | Length | 8 m |
| Piles | Piles | On |
| Piles | Pile rows | 2 |
An approach slab length of 0 leaves the slab out.
Add a bridge study
In the Explorer, right-click the Analysis stage and choose Add study. Pick the pushover type, “Fibre sections, push to a target drift”. In FEA OpenSees Bridge every pushover and time history is a bridge study.
Select the new study. Its Bridge seismic group shows in the Properties panel.
Bearings and abutments in the seismic model
In the seismic model each bearing becomes one link from the cap to the girder. Held directions keep the bearing’s stiffness. Elastomeric pads use their elastic stiffness. Pot bearings slide in their free directions by friction.
| Property | Default | What it does |
|---|---|---|
| Bearing friction μ | 0.04 | Sliding pot bearings in their free directions: elastic–plastic, sticking up to 2 mm. |
| Abutments | Backfill and shear keys | Hyperbolic backfill springs behind the back wall after the expansion gap, and shear keys across. Fixed seats keeps the bearings on fixed seats. |
| Expansion gap (mm) | 25 | The gap before the backfill is reached. |
| Shear key strength (× dead load) | 0.3 | Shear key capacity as a fraction of the abutment dead load; 0 means no shear keys. |
| Foundations | Fixed | Springs: a surface footing of the pile cap or footing size on soil of the study shear modulus (Gazetas). Piles are not counted. |
Leave the defaults and run the study in the next tutorial.
The backfill and shear key values come from Caltrans SDC. They have not yet been checked against the published document. See Capacity checks.
What you learned
- The template sets the bearing layout; each bearing can be changed on its own.
- Abutments have a wall, footing, back wall, wing walls, approach slab and optional piles.
- The seismic studies model bearings as links, and abutments as backfill and shear keys or fixed seats.