1

Give the columns their bars

The fibre sections need reinforcement. There are two ways:

  • Design the columns. Run Analysis › Linear static, then Design › Design…. If a column design covers a pier column, the pushover uses its bars.
  • Use a steel ratio. Columns without a design get the ratios set in the study (next step), with 32 mm bars.
2

Set the section properties

Select the bridge pushover study from the last tutorial, or skip this step and use the defaults. In its Bridge seismic group:

PropertyValue
DirectionAlong the bridge
CodeAASHTO Guide Spec
Column steel ratio ρl (%)1.5
Spiral or hoop ratio ρs (%)0.8
Expected strengthsOn

Direction is the push of the whole bridge. The bent pushovers always run both ways. Expected strengths uses f′ce = 1.3 f′c and fye = 1.13 fy.

3

Run the bridge pushover

Choose Analysis › Bridge pushover. It runs the existing bridge pushover study, or makes one called Bridge pushover first. A new study pushes with a uniform pattern to 4 % drift in 80 steps.

To run a study you selected in the Explorer, press F5.

After the whole-bridge push, each bent is pushed along and across on its own. Up to four bent runs go at once.

If the command says no bridge piers were found, the model has no recognisable piers. Use a girder bridge template, or put the pier columns in a group named “Columns”.

4

What OpenSees is given

  • Pier columns: RC fibre sections, circular or rectangular from the column shape. Other shapes become a circle of equal area.
  • Concrete: Mander confined core and unconfined cover, with no tension.
  • Bars: Steel02, with a reduced ultimate strain of 0.09 for bars up to 32 mm and 0.06 above.
  • Plastic hinges: at the column base, and also at the top for multi-column bents. Lp = 0.08 L + 0.022 fye dbl ≥ 0.044 fye dbl.
  • Bent caps: elastic, 0.75 Ig. The superstructure stays uncracked.
  • Wall piers made of shells stay elastic.

For each bent and direction, the column’s moment–curvature is found at its gravity axial force. The bent pushover runs to the first strain limit, or until the strength falls to 80 %.

5

Read the charts

Choose Results › Seismic charts. Each chart opens as a tab in the main area. Pick the bent and direction in the chart, for example “P1, along”.

ChartShows
Bent pushoverBase shear against seat displacement, the idealised curve, the capacity Δc, the hand capacity and the demand ΔD.
Column moment–curvatureThe section curve and its idealisation, first yield and ultimate curvature.
Bridge capacity and demandEvery bent and direction: capacity against demand, or ductility demand against the limit.

In the 3D view, a ring at each column base shows the bent’s state: green within the limits, amber past 80 % of a limit, red failing.

What you learned

  • The pushover uses designed column bars where there are any, else the study’s steel ratios.
  • Analysis › Bridge pushover pushes the bridge and then each bent along and across.
  • The charts show each bent’s moment–curvature, pushover, capacity and demand.